AK Variant Discussion
All the AK stuff goes here.
668 topics in this forum
-
- 64 replies
- 33,672 views
-
- 6 replies
- 4,977 views
-
- 21 replies
- 903 views
-
- 6 replies
- 1,470 views
-
- 6 replies
- 378 views
-
- 2 replies
- 390 views
-
- 20 replies
- 856 views
-
- 6 replies
- 1,055 views
-
- 2 replies
- 473 views
-
- 9 replies
- 642 views
-
- 12 replies
- 840 views
-
- 6 replies
- 792 views
-
- 8 replies
- 496 views
-
- 5 replies
- 505 views
-
- 15 replies
- 1,147 views
-
- 2 replies
- 724 views
-
- 7 replies
- 1,408 views
-
- 3 replies
- 542 views
-
- 2 replies
- 486 views
-
- 50 replies
- 4,776 views
-
- 1 reply
- 1,563 views
-
- 2 replies
- 770 views
-
- 0 replies
- 775 views
-
- 1 reply
- 1,090 views
-
- 28 replies
- 1,459 views
-
-
Topics
-
-
-
Supporting Vendors
-
-
Posts
-
I was in Dicks Sporting Goods in Moorestown last week and they completely stopped selling firearms and ammo. Didn’t even see any hunting gear or targets etc. they said they stopped in January. So you won’t be able to buy a shotgun there anymore. -
By this_is_nascar · Posted
I agree. The goal here has to be to vote out every Democrat currently holding a position. There can't be any exceptions and it has to be by the masses. I hate to say it, but this should be the easiest vote ever cast. If they are Republican, vote for them. -
-
-
By ethanjordan · Posted
Since the new Dark Series Marlins are so scarce, I decided to make my own. I got the Glenfield 30AW from my stepson recently And decided to use it as a base guI am either going to sand the checkering off the butt stock and paint it black with a light texturing, or buy one already done from Marlin. I ordered a mag tube hanger, plug, and screw from Marlin, and as soon as it gets in, I am going to send it off to Powers Metal Works to have the barrel cut and threaded, front sight installed, and a recoil pad added (not because of the recoil, but the rubber pad doesn’t slide when you lean the gun against the wall). Then I am gonna have Mr. Clean put a matte black Ceracoat paint job on it. Parts already installed are; Ranger Point Precision hand guard Ranger Point Precision Medium loop XS Lever rail (back half) Parts I’ll probably add later: Ranger Point loading gate Aluminum or brass mag tube follower Hand stop of some kind Paracord wrap on the lever Claw sling Ammo quivers Either a red dot or a low power scope of some sort.
-
-
