Reputable smith in south jersey to pin and weld brake ?

[robs609 2]

Can anyone point me to a good gunsmith that can pin and weld my upper so I can shoot this thing?

 

I took a ride out to Bangers today since I got a good recommendation from someone I trust but the owner is not currently taking work due to their shop expansion.

 

Thanks in advance.

[maintenanceguy 510]

John Torelli in Millville has a good reputation. I haven't used him but several people I know have and everyone has been very pleased with his work.

 

http://jtjersey.com/

[My1stGlock 144]

If Central Jersey is doable give Steve @ Monmouth Arms a call or PM here on the forum. His handle is remixer.

 

 

using Tapatalk

[remixer 1,645]

I'm here.... Iv always been here LOL

[obracer12 1]

If you're near Deptford, 1924 Cooper St, Deptford Township, NJ 08096

Ed's is a little mom and pop and does great work, if you're looking for 24 hour turn around though this isn't the place.

 

[robs609 2]

Thanks for all of your suggestions. I am still weighing my options. Hey remixer. Its about a 2 hour drive from where I am to your shop. I sometimes come out that way to watch my buddy drift at the racetrack. Is there a specific day you do the work or could I leave the upper with you for a few hours and have it done or is that not enough time. I have the vg6 break and the hole is already drilled . Just need to go into the barrel a bit.

[silverado427 10,731]

Thanks for all of your suggestions. I am still weighing my options. Hey remixer. Its about a 2 hour drive from where I am to your shop. I sometimes come out that way to watch my buddy drift at the racetrack. Is there a specific day you do the work or could I leave the upper with you for a few hours and have it done or is that not enough time. I have the vg6 break and the hole is already drilled . Just need to go into the barrel a bit.

 

I would PM remixer. He may not read this post

[remixer 1,645]

Im here.

 

What day do you watch your friend drift?

[remixer 1,645]

I usually do brakes on saturday morning 7am.

but we can work something out for a sunday and you can pick up a bit later in the day

[remixer 1,645]

Do you have a 16" barrel?

[sideshowbob 0]

Also looking for a good smith for pin and weld, but in North Jersey/Bergen.  Anyone have any recommendations?  Thanks.