vjf915 456 Posted July 13, 2018 On 6/24/2018 at 2:42 PM, GlennS87 said: Just so you know, they make 10 round mags for both 9mm and 357 Sig full size. I have a full size 9mm and I bought the 357 Sig conversion kit. It came with a 14 Rd mag but I bought a 10 Rd mag from Sig in anticipation of this B's law. Right, but if you're going to be limited to 10rds either way, why not go with the bigger round? I know, I know, cost of ammo. I have a P320 Compact, purchased it post-upgrade. I absolutely love it, it's my favorite striker fired pistol. Quote Share this post Link to post Share on other sites
GlennS87 65 Posted July 13, 2018 For home defense I have it set up with 357 Sig. When I go to.the range I shoot both so I can practice. I also bring my AR each time as.well. Quote Share this post Link to post Share on other sites
JohnRyan 12 Posted July 16, 2018 I've had my 320c w/manual safety for about a year. Trigger was upgraded, process was fairly smooth. Can't say the new trigger is any better or worse than before. Still trying to dial this thing in. Prior to purchasing I shot a rental and had no problem shooting quarter sized groups with it. I wish I could shoot the one I wound up purchasing like that. Last time out my groups with my 9mm shield w/short magazine put my 320c groups to shame. Should be the other way around given my hand size. Had to replace the front sight with a #6 because POI with too high on the installed #8. Contacted sig support about this and they told me to go fly a kite and purchase the Sig #6 front sight from their store. I did and installed it which fixed my elevation issues. Still need to drift it back out and file it down a little bit because it's not sitting perfectly flat. Remaining problem is that I am shooting a bit to the right. Inspection would indicate the rear sight is not on center. I'm almost there... Quote Share this post Link to post Share on other sites
Vicious 138 Posted July 16, 2018 On 7/6/2018 at 10:00 AM, Persona non grata said: Strange. They used to. Even had models with suppressor-height sights if my memory serves me correct. I have suppressor height sights on my RX, no threaded barrel though. Quote Share this post Link to post Share on other sites
Zeke 5,504 Posted July 16, 2018 Next time I’m at shooters I’ll rent one. you guys are all over the place with good v bad. Quote Share this post Link to post Share on other sites
TokenEntry 293 Posted July 16, 2018 Here's a video just put out by Mrgunsngear regarding the POST recall upgrades done on the Sig P320. It's very good review of each of the changes done by Sig Sauer. Regards, TokenEntry Quote Share this post Link to post Share on other sites
High Exposure 5,664 Posted July 16, 2018 1 hour ago, Zeke said: Next time I’m at shooters I’ll rent one. you guys are all over the place with good v bad. 1 Quote Share this post Link to post Share on other sites
Zeke 5,504 Posted July 17, 2018 6 minutes ago, High Exposure said: Wts Lana! Quote Share this post Link to post Share on other sites
Zeke 5,504 Posted August 11, 2018 Cking gunbroker these can be had @$400 not a huge risk Quote Share this post Link to post Share on other sites