Celraysoda 7 Posted April 15, 2013 Installing an in-wall appliance that is 15" wide so figured it would fit nicely in between studs. Where I want to put it, on the other side is another wall making a T. I opened the wall and instead of two studs 16" from center, there are 4 studs, 4" apart. They don't seem to be load bearing as I tried all the tests I can think of: wiggle test, cutting halfway and seeing if blade pinches, checking attic for any major beams...nothing. Go ahead and cut out the two studs? I really can't double plate because of electrical wiring. Any body know why there would be studs 4" apart from center? Quote Share this post Link to post Share on other sites
heaterbob 53 Posted April 15, 2013 the distence between two studs is 14 and 1/4. the two studs 4 inches apart probably means there is a wall on the other side going away from you. Quote Share this post Link to post Share on other sites
Celraysoda 7 Posted April 15, 2013 Precisely. There is a wall on the opposite side going away from me making a T. Safe to remove then. Quote Share this post Link to post Share on other sites
Night Prowler 0 Posted April 15, 2013 Sounds like your pile of studs is your connection point between the two walls. Kind of needs to be there as this gives rigidity to the other wall. Without them your corner joints in the sheet rock might crack. As for load bearing if you have a basement check directly below the wall. Large beams or posts is a sure sign of load bearing. Depending on how much depth you need you might be able to remove the studs and patch plywood between the studs to attach the other wall to. Quote Share this post Link to post Share on other sites
TommyGun 5 Posted April 15, 2013 Like you said, the other side of the wall comes in on a "T" is probably the reason for the 4" spacing. Try to create a header with hangers at least. Quote Share this post Link to post Share on other sites
heaterbob 53 Posted April 15, 2013 cut out a little mor than you need and cat it off, you will also probably have to fix the two corners on the other side those two studs hold the sheetrock corners together Quote Share this post Link to post Share on other sites
MB24 37 Posted April 16, 2013 the 2 studs that are 4 " apart are the nailers for the sheetrock in the corner of the other room. Quote Share this post Link to post Share on other sites
pjd832 146 Posted April 16, 2013 the 2 studs that are 4 " apart are the nailers for the sheetrock in the corner of the other room. This is what I'm saying also without seeing it....if that is the case... Bad idea to remove them as there will be no backing for the inside corners in the other rooms and would no doubt be an oncoming problem with the corner cracking Quote Share this post Link to post Share on other sites
silverado427 10,893 Posted April 16, 2013 the 2 studs that are 4 " apart are the nailers for the sheetrock in the corner of the other room. Bingo we have a winner Quote Share this post Link to post Share on other sites
Tunaman 567 Posted April 16, 2013 It's called a partition stud. Do not remove unless you want to re-sheetrock the inside corners of the adjoining room. The sheetrock is probably nailed or screwed to this stud so be prepared to fix it. You can put a different type of nailer in there if you decide to rip it out. Not an easy job, but quite doable using a bit of ingenuity. Quote Share this post Link to post Share on other sites
djg0770 481 Posted April 17, 2013 sometimes it's easier to just pick a different location... Quote Share this post Link to post Share on other sites
PhilipJFry 4 Posted April 17, 2013 load bearing walls are perpendicular to ceiling and floor joists. Quote Share this post Link to post Share on other sites