High Exposure 5,664 Posted December 27, 2016 The only fitting required on the AKT trigger (not all AKs) is for the depth of the safety stop (roll pin) which is clearly noted on the instructions. Really simple installation if you have a roll pin starter Took all of 2 minutes with a good file for fit and a pair of channel locks to sink the roll pin. Quote Share this post Link to post Share on other sites
TokenEntry 293 Posted December 27, 2016 Did the ALG trigger drop right in or did you have to do some fitting? I have the same rifle and was thinking of switching up the trigger. Did your original G2 cause any bolt hang ups when hand cycling? Any hang ups with the new trigger? The ALG AKT was a drop in. I did not need to use the roll pin at all. The original trigger that came with the rifle was not a Tapco G2. I don't know who mfg. it as there was no markings. I've compared it to other Tapco triggers and it is definitely not one of theirs. There was some bolt hang up but nothing like a little of Flitz metal polish couldn't fix in 20 mins. on the hammer and bolt and carrier. Regards, TokenEntry Quote Share this post Link to post Share on other sites
leo-польд 35 Posted December 30, 2016 some Commie goodness I like this "soviet pioneer" red star, I got the same when I was in second grade there, that was long ago Quote Share this post Link to post Share on other sites
shooter28 153 Posted January 14, 2017 Made a few upgrades Quote Share this post Link to post Share on other sites
younggun93 5 Posted January 15, 2017 Made a few upgrades have you ever had any issues with that stock loosening up while shooting? because for the life of me i can't get mine to stay in place, no matter how much blue lock tight i use Quote Share this post Link to post Share on other sites
shooter28 153 Posted January 15, 2017 have you ever had any issues with that stock loosening up while shooting? because for the life of me i can't get mine to stay in place, no matter how much blue lock tight i use Yes. I switched the screws around opposite the directions say to. I believe I put the longer screw in the rear and shorter one up front. That seemed to have fixed the issue. 1 Quote Share this post Link to post Share on other sites
fatty 241 Posted October 5, 2017 MAK90 (with a 15/30 polish surplus magazine) Quote Share this post Link to post Share on other sites
DeletePLS 178 Posted October 5, 2017 3 hours ago, fatty said: MAK90 (with a 15/30 polish surplus magazine) magazine doesnt look polished to me Quote Share this post Link to post Share on other sites