Judge Jeanine Pirro Exposes Journal News Outing her as Gun Owner!
By
dgstinner, in General Discussion
-
Recently Browsing 0 members
No registered users viewing this page.
-
Use Promo Code "NJGF10" for 10% Off Regular Items
-
Supporting Vendors
-
-
Latest Topics
-
-
-
Posts
-
Handloading is the only real way you can control the quality of all components used! Still no guarantee but I use only CCI primers and I am certain that the proper amount of a good quality powder is there. Not much else you can do! -
There is a lot of crappy factory ammo out there. A name like Remington and you cant even trust them with your life. A few different instructors told me that they have been seeing some real shit ammo too. For me...I'll continue to make my own. I know it works. ALL of them. -
-
By Cheflife15 · Posted
I think this ammo was bought during the pandemic where it seems like quality control went out the window. I should have taken a picture of the primers today after shooting. Some had some pretty deep indents. I shoot da/sa. The thing that was a bit alarming was sometimes it didn't go off on the second attempt of dropping the hammer and sometimes it did. -
It’s possible it’s the ammo. Try a box of something from Federal-Federal primers are known to be the ‘softest’. If you get misfires still, the gun is again the prime suspect of course you’ll ultimately want it to run with any ammo, but I’ve known revolvers that can’t seem to get to 100% ignition double action with any other primer
-
-
