-
Supporting Vendors
-
-
Latest Topics
-
-
Similar Content
-
By Dooly
BCM BCG. New in sealed factory wrap.
$240 shipped.
I accept PP (F&F), venmo, cash. I am in Bergen County.
First to reply "I'll take it" wins the sale.
-
By Swizz70
Hello Gents,
I'm selling my (like new) AR mid length complete upper receiver chambered in 300BLKOUT 7.62 × 35mm manufactured by Special Ops Tactical. Only put approximately 100 rounds through it. For those of you who don't know, this basically will fit on most AR lowers and uses the same AR magazines but gives you a .30 caliber (7.62 x 35) by just swapping the upper receiver if you are looking for a heavier load and more knock down power for hunting etc. (obviously state laws apply). I'm only selling it because I ended up buying a complete .30 caliber rifle.
Here are some specs:
300 BLK Out Nitride - 14.5″ Pinned to 16" Overall Midlength Upper
GPX 12.6" MLOK Free Floating Rail System with continuous 1913 Picatinny rail on top
Muzzle Brake Original "Black Magic" 30 Cal (pinned & welded NJ legal).
{Nitride} M4 Extended Feed Ramps
Nitride M4 Barrel Extension
1:7 Twist Rate
5/8×24 Thread Pitch
Raptor Charging Handle
Price: $695
Pm or email me with any questions: [email protected]
I am in Deptford NJ.
THE FIRST TO POST "I'LL TAKE IT" WINS THE SALE.
A "PM sent" DOES NOT ESTABLISH THE SALE. If you want the item, post "I'll take it" and should the deal fall apart the seller can post "still available." Should you reach a negotiated price via PM then post "I'll take it per our PM(s)" on this thread.
-
By M1152
Up for sale, 260 rounds of 300 AAC BlackOut 124 grain FMJ by Sellier Bellot –SB300BLKA for $182 (cash sale) for local pickup in Mercer. Can be shipped for additional cost. Will throw in slightly used RFA barrel with 1/8 barrel with small cosmetic blemish on threads for additional $20 for grand total of $202. I will not ship barrel to keep shipping cost low. Buyer must have NJ FID card and matching DL for ammo purchase. The first to post "I'll take it" wins the sale (not responsible for typos)
-
By Tactical Monkey
Fellow 300Blk enthusiasts,
I went shooting on Saturday and found a live .223 round inside a box of Remington UMC 115gr 300 AAC Blackout. It was a new box, unopened, and I did not have a .223/5.56 rifle with me that day. For my own sanity, this prompted me to go through every box of Rem 115gr 300Blk that I have (32 boxes).
The lot number of the box with the .223 round was N16 VBI. The lot number can be found on the tab that folds inside the box, beneath the thumb cutout (see picture below). I purchased 17 boxes of Remington UMC 115gr from MidwayUSA on 5/21/12, all with that same lot number. Out of the small sample of boxes I purchased, I found 4 boxes that each had 1 live .223 round in the box. The rounds were head stamped "223 REM", and looked as though they came right off the production line.
.223 round
Headstamped 223 REM among 300 AAC BLACKOUT
Remington Lot # N16 VBI
Please be careful and check all your Remington UMC 115gr 300Blk just to be safe. I had 2 other lot numbers in my possession and all those boxes checked out. Be very thorough if your lot number is the one mentioned here, as with a small sample size of 17, I had a very high rate of failure.
Remington has been contacted about the issue.
Updating this thread 6/8/12:
Received 2 brand new boxes of ammo free of charge for the inconvenience straight from Remington's ammo plant. The rounds came after I spoke in-length with the Director of QC.
Thanks -
TM
-
-
Posts
-
So, as I interpret things, you get a hit on #1. It says nothing about feeding from said magazine, just that the magazine attaches to the pistol outside of the pistol grip. And it is attached. Was this what was considered when it was written? 100% no. However, this is NJ and I don't think they would give you an inch when as written it covers it in plain english. #2 would be a hard yes if you put a threaded barrel on your setup, so I'd not do that. #3... well it's not a shroud, but it does allow you to hold the firearm with the nontrigger hand without being burned. Shroud is ill defined, and it could be argued to partially enshroud the barrel from the bottom. I would bet cash money that the AG would gladly say that second part there is to clarify the intent of the law and that since you can do that, you violated the stated intent of the law.
-
I don't know why we ( NJ gun organizations ) have not yet filed a lawsuit on "duty to inform" A clear violation of the constitution 5th and probably 4th. Maybe this guys lawyer will and get that charge dropped. what other right do you need to inform a law enforcement officer of. are you required to identify as a republican or democrat during an encounter, and by the way, what constitutes an encounter. voluntary? involuntary? time to get this one knocked down. come on ANJRPC stop waiting for court decisions and go on the attack.
-
Right, each location will have a different set of Repeater frequencies you can use in your area. You could also just have 2 sets of CHIRP files ready to go and make sure you have the ability to program them quickly in a SHTF situation. Maybe dedicate at least one radio for each location with specific programming, and then when you get there you can re-program the radios you take with you with the programming specific to that location. More expensive radios have the ability to program them via your phone app and BT connection.
-
-