Hooligan 0 Posted January 30, 2014 I want to keep a few 5 gallon cans on hand. What is the best way to store containers of this crappy ethanol gasoline, and how long will they last? The best method I've heard so far is to use stabilizer formulated for the ethanol gas, and to keep cans filled to the top and sealed to minimize the amount of air (and moisture) inside the can. I'm curious to see other's ideas and solutions for gasoline storage. Quote Share this post Link to post Share on other sites
Secret Squirrel 3 Posted January 30, 2014 Normally I keep it in this 18.7 gallon rupture proof tank, I keep it hidden behind the rear axle of my car.... serious note, Gasoline is not a good thing to keep hanging around for long periods of time, goes stale even with stabilizer after a while and it is very volatile as opposed to diesel. Quote Share this post Link to post Share on other sites
T Bill 649 Posted January 30, 2014 I find Startron is best to stabilize. I rotate and stabilize the fuel as it is purchased. I have a 14 gallon tank and a 5 gallon can. Of course the generator tank is always full also (7gallons). Cans are stored in a mini shed away from the house. I only use high test (92 octane) in all the small engines, all starting problems have gone away. If time is up on the storage cans or genny (6 months, doesn't happen often), it goes into the car's tank, and start again. Have two Eagle metal safety cans (1 and 5 gallons), the 14 gallon is poly with a gas station type hose. Also have poly jerry cans that can be used in an emergency. Quote Share this post Link to post Share on other sites
louu 399 Posted January 30, 2014 If your planning for the end of the world go to a small airport and get 100LL, it has a 7 year shelf life. Quote Share this post Link to post Share on other sites
Vlad G 345 Posted January 30, 2014 I keep mine if 5gl cans with a double shot of Stabil. One year is no challenge, I've used it in both my car and my generator and lawnmower after that time with no difference in performance. Normally I rotate it every 6months. Now the real problem if finding cans which aren't garbage and leak or can't use the damn contraption they call a spout and so on. Quote Share this post Link to post Share on other sites
CMJeepster 2,778 Posted January 30, 2014 Now the real problem if finding cans which aren't garbage and leak or can't use the damn contraption they call a spout and so on. Briggs & Stratton has a great product. Quote Share this post Link to post Share on other sites
Vlad G 345 Posted January 30, 2014 Briggs & Stratton has a great product. This one? http://www.amazon.com/Briggs-Stratton-85053-5-Gallon-Compliant/dp/B001QCWQUS I have one that seems to be 100% clone of it, everything but the label so probably made in the same chinese factory, and it leaked "upwards" on me.. As in up the spout stored inside the can, and leaking through the cap. If you mean the metal ones, I've been looking at that but those are some expensive cans. Quote Share this post Link to post Share on other sites
beachwhistle 28 Posted January 30, 2014 I have 3 cans with that spout. Only one spout works the other two leak as you pour. Real PITA Quote Share this post Link to post Share on other sites
Sota 1,191 Posted January 30, 2014 Sceptre uses the same nozzle assembly. when reversed with the cap insert it seems to do a great job of not leaking fumes, but it's a total #%)*! to actually use and poor... and it's SO SLOW since the air vent is in the same tube. Also since they don't vent it's a really good idea to keep them full when storing them, otherwise the vapor pressure can get pretty high and buldge the container. I had one that was approaching spherical... quite frightening. Quote Share this post Link to post Share on other sites
maintenanceguy 510 Posted January 30, 2014 Multiple 5 gal cans. I mow 1-1/2 acres so I have plenty of opportunity to rotate my stock through my mower. I keep 5 cans full at all times - empties go in the back of my truck and get filled the next time I'm at the gas station. Quote Share this post Link to post Share on other sites
CMJeepster 2,778 Posted January 30, 2014 This one? Yep. I've got a few of those and some other no-name ones and I like the B&S ones the best. Their spouts also seem to be the best when I pour gas into the vehicles or power equipment. I grabbed mine from AutoZone the day before Sandy. I had 33 gallons on hand plus 3 full vehicle tanks. I never got below ~15 gallons of reserve during that time. We only lost power for about 48 hours. I keep my 7 gallon generator tank filled & treated and at least one 5 gallon can (treated with Sta-Bil) ready to go. If I get a threatening forecast, I'll go fill everything to capacity and run the leftovers afterwards through the vehicles. Quote Share this post Link to post Share on other sites
Vlad G 345 Posted January 30, 2014 Annoyingly the new new CARB compliant cans leak, spill, and screw up a lot more then older cans. Good job government at ruining a perfectly fine product and in the process making it worse even along the vector you were trying to "help"! Quote Share this post Link to post Share on other sites
Howard 538 Posted January 30, 2014 I have three 5-gal cans for the generator stored in the shed. Every other month I dump on into the car gas tank and have it refilled. Quote Share this post Link to post Share on other sites
10X 3,300 Posted January 30, 2014 If your planning for the end of the world go to a small airport and get 100LL, it has a 7 year shelf life. Much longer shelf life, yes. Hard to find for under about $6/gallon. And it is leaded fuel--you can't cycle it through your car without killing the catalytic converter and probably the oxygen sensor. Quote Share this post Link to post Share on other sites
Babyface Finster 45 Posted January 30, 2014 No need to worry about stabilized gas going bad in a year. I've had cars sitting for years with 1/4 tank or less of non-stabilized gas and they fired and ran fine. With stabilizer, a year should be absolutely no problem. I store in regular, red plastic cans. Never had a problem. Quote Share this post Link to post Share on other sites
njpilot 671 Posted January 30, 2014 I have a couple of these: http://www.amazon.com/No-Spill-1450-5-Gallon-Poly-Compliant/dp/B000W9JN4S/ref=sr_1_2?ie=UTF8&qid=1391093383&sr=8-2&keywords=Gas+cans No leak from these and they do pour quickly if needed. No like those that drip, drip, drip. Quote Share this post Link to post Share on other sites
TheLugNutZ 21 Posted January 30, 2014 I use 5 gal gas cans. Re-fill every year and add stabil at 6 months... I have 4 5 gallon cans, 2 2gal cans and a 1 gal can. The 5 gallon and 2 gallon cans are filled with regular gas, then I use the 1 gal can for my 2 stroke mix. All of the gas is used for the genny if needed and landscaping stuff. I just dump what doesnt get used after a year in the cars and start over... So I usually have about 20gal or so on hand if needed.. Quote Share this post Link to post Share on other sites
TOMMY R 24 Posted January 30, 2014 Most people don't know that you can buy race fuel its expensive but doesn't contain ethanol on average it will last years on its own. I have used it for gensets for years no issues. Don't believe me do a little research you will be surprised. Quote Share this post Link to post Share on other sites
TheLugNutZ 21 Posted January 30, 2014 Nothing like 105 octane non-enthanol gas! Quote Share this post Link to post Share on other sites
TOMMY R 24 Posted January 30, 2014 Got off target on storage I like the all steel type surplus cans, I buy the tank sealant that lines the inside then treat the outside with with truck bedliner pretty much indestructible. Quote Share this post Link to post Share on other sites
JonF 79 Posted January 30, 2014 I picked up a couple of the EZ Pour replacement spouts for a couple repeated use cans and they flow so much faster, easier and hassle free. You do need to modify the can by drilling a small hole for an air vent, but after that its all gravy. http://ezpourspout.com/wp/ Quote Share this post Link to post Share on other sites
maintenanceguy 510 Posted January 30, 2014 I've put the EZpour spouts (I really have no idea of the brand I used) on all of my cans - gas, diesel, kerosene. So much better than the new "better" spouts. If you're keeping gasoline in your generator or other equipment, the most damage is done when gasoline evaporates from the carburetor leaving thick, gummy residue behind. This eventually hardens into what I've heard referred to as "varnish". I've never experienced gas that goes bad and I grew up on a farm where we had dozens of different kinds of gasoline equipment - some of which would sit for years unused. I have experienced problems with gummy residue and varnish in carburetors. When I'm storing something with a full tank I turn off the fuel petcock and run the generator until it stalls from lack of gas. I then crank the engine a few times while spraying WD40 into the carburetor's air intake to lightly lube everything since there isn't any gasoline to prevent corrosion or rust. Quote Share this post Link to post Share on other sites
TheLugNutZ 21 Posted January 30, 2014 Ahh drilling a hole for an air vent is a good idea... Is there any specific area to do it, or a valve that you should use as well? Those new cans def do not pour well at all with no vent.. Quote Share this post Link to post Share on other sites
fishnut 2,358 Posted January 30, 2014 5 gal Blitz jerry cans that get rotated through every engine I own. from cars to lawn tractors to snow blowers. I have never use any fuel stabilizer and have never had a problem but I guess that's because use the gas up pretty fast. Quote Share this post Link to post Share on other sites
JonF 79 Posted January 30, 2014 Ahh drilling a hole for an air vent is a good idea... Is there any specific area to do it, or a valve that you should use as well? Those new cans def do not pour well at all with no vent.. The EZ Pour kit comes with a vent to install. Basically, the OEM spouts have a vent built into the constricted stock spout whereas the EZ pour is a plain nozzle with no trickery hence the need for a seperate vent. Best to put it as high as possible and on a flat part of the can. Quote Share this post Link to post Share on other sites
Vlad G 345 Posted January 30, 2014 Note that amusingly in NJ you not buying the EZ-pour fuel nozzle kit, you are buying the water can kit. Quote Share this post Link to post Share on other sites
TheLugNutZ 21 Posted January 30, 2014 lol^ I was wondering what the difference was.... Quote Share this post Link to post Share on other sites
maintenanceguy 510 Posted January 30, 2014 http://www.tractorsupply.com/en/store/spout-kit-for-water-jugs Quote Share this post Link to post Share on other sites
HBecwithFn7 296 Posted January 30, 2014 Unfortunately, as owners of a townhouse (multiple unit dwelling), we are not allowed to store gasoline in separate containers or similar flammable materials. We can't have propane tanks/bottles either. We can only use the "plumbed" main line natural gas we have for heating/cooking, etc. The State comes to inspect our units every 5 years for stuff like that. We have to have working CO and smoke detectors, etc. Quote Share this post Link to post Share on other sites
TheLugNutZ 21 Posted January 30, 2014 ^ Exactly why I said HELL NO to townhomes/condos/associated neighborhoods when we were house shopping. screw that! Quote Share this post Link to post Share on other sites