Longtime resident Lady Liberty, age 236 was struck by a stolen Chevy Volt last night along the interstate. The driver and passengers, illegally in the US from their native countries across the world, then dragged Ms. Liberty into the woods and brutally sodomized her before heading to the local polling place where they registered using the names of Supreme Court justices and voted without being challenged by UN poll watchers.
Authorities found them around the corner, each with a large supply of newly legalized recreational marijuana, getting high. They were taken into custody and released a short time later with a kiss on each cheek and a prepaid gift card for WaWa to handle the munchies.
Ms. Liberty is in extremely critical condition in the Intensive Care Unit, and doctors are very wary of her chances of recovery. A crowd of zombie-like citizens are already gathered at the Liberty residence, preparing to loot it of valuables when she succumbs to her injuries or the Death Panel declares her worthless and pulls the plug.
Handloading is the only real way you can control the quality of all components used! Still no guarantee but I use only CCI primers and I am certain that the proper amount of a good quality powder is there. Not much else you can do!
There is a lot of crappy factory ammo out there. A name like Remington and you cant even trust them with your life. A few different instructors told me that they have been seeing some real shit ammo too. For me...I'll continue to make my own. I know it works. ALL of them.
I think this ammo was bought during the pandemic where it seems like quality control went out the window.
I should have taken a picture of the primers today after shooting. Some had some pretty deep indents.
I shoot da/sa. The thing that was a bit alarming was sometimes it didn't go off on the second attempt of dropping the hammer and sometimes it did.